Washer, Cylinder Head Bolt - Toyota 1HZ, 1HDT (11mm)
90201-11032
Toyota - Japan
| Article number: | 90910-02096 |
| Availability: | In stock (3) |
Torque to Yield Head Bolt set
M11x1.25 x 26 pcs
Head bolt washers are not included with the head bolt set. If you require these parts, please see: Head Bolt Washer 11mm
Toyota pn:
90910-02096 (26 pcs)
Genuine Toyota
We recommend replacing your head bolts when you are repairing or replacing your cylinder head or cylinder head gasket.
Note 1: Make sure the head bolt holes are properly cleaned out and fully dry prior to head bolt installation. Leaving solvent, water, or debris in the holes may cause improper torque or the threads to become damaged of stripped.
Note 2: that you use several drops of light oil on the threads, and a small amount of rebuilder’s grease or a drop or oil under the head of bolt and both sides of the washer while torquing in to place. Torque in 3 steps to 51 Ft. Lbs, then +90* & +90*.
The best lubricant for this task is ARP's Ultra Torque bolt lubricant 100-9908 (0.5 ounce packet), or 100-9909 (1.69 ounce tube).
If you are going to risk re-using your old bolts, use vernier calipers and carefully measure the minimum outer diameter of the compressed thread at the measuring point (see Toyota FSM for details).
Standard outer diameter: 10.800-11.000 mm (0.4646-0.4724 in.)
Minimum outer diameter: 10.55 mm (0.4154 in.)
If the outer diameter is less than minimum, replace the bolt.
7318.15
2,600
2021 12 09
9091002096
