Alternator harness adapter for 3-pin round (IR7) sockets to newer 3-pin oval (IR11) style
see image for details
| Article number: | 27060-17240 |
| Availability: | In stock (2) |
Please read the product description below for important installation information
Part No.
27060-17240 = oval plug on back
27060-17120
Replaces:
27060-17060 24V 30A (round plug) 01/1990 - 07/1992 (end of 1992 model year)
27060-17190 24V 30A (oval plug) 08/1992 - (start of 1993 model year to ??)
Read the notes... there is important information here.
Seriously, take the time to read this stuff.
Note 1: this is a high output alternator. It is strongly recommended that the alternator to battery wiring be upgraded to at least 8ga and preferably 6ga finely stranded copper wire and protected with an appropriately sized fusible link.
Fusible links are typically sized 4 wire gauge sizes smaller than the wire they are protecting (eg: an 8ga wire is protected with a 12ga/3.0mm fusible link, and the section of link should be about 4" or 10cm in length).
Note 2: this alternator has a larger case size than the stock 30 Amp alternator, and the alternator adjusting bar must be upgraded to 16381-17020 (<-- click the link and add this item to your cart) that is listed here otherwise you will have difficulty fitting it into place.
Note 3: This alternator is equipped with the later style oval socket on the rear of the alternator. Earlier alternators with the round socket are going to need the harness updated for the oval plug. There is an alternator harness adapter required (<-- click the link and add this item to your cart) if you have the earlier round plug on your alternator wiring harness that plugs into the back of the alternator.
Note 4: Ensure your batteries are fully charged and in good condition OR replaced with new units before hooking up this new alternator. Weak or dead batteries will kill your new alternator.
• Make sure your battery terminals and connections are in excellent condition. Ensure your frame and engine block ground points are clean and tight. High quality battery terminals are recommended.
• Most JDMs arrive from overseas with ancient, low performing batteries still in place - the vast majority of these are junk. We recommend you install two new high quality group 27 (or larger) batteries in their place.
Toyota pn:
27060-17240
Interchanges with and replaces:
27060-17190
27060-17060
Aftermarket - Malaysia
No warranty on electrical items
8511.50
2021 11 18
2706017240
2706017190
2706017060
